Ikea Hack: Cobalt Office Chair
May 29, 2015
DIYHome DIYIkea Hack
You know we love ourselves a good Ikea hack. Love might not even be strong enough a word. And this one is practically unrecognizable from the standard store bought offerings with a pop of glossy cobalt and some leopard for good measure. This office chair is not shy but that's why we love it so. Give an Ikea piece an oh-so glam update with this fab project. And for even more Ikea hacks, click here!
Materials

Ikea chair
Chair wheels
Gloss cobalt blue spraypaint
Gold spraypaint
7/16” drill bit
Drill
Super glue
Hammer or mallet
Leopard fabric
2” thick foam sheet large enough for the seat diameter (we found ours at Joann’s)
Hot glue gun & sticks
Scissors
Sharpie
Pencil
String
Ruler
Fabric measuring tape
Bread knife

instructions

step-1Drill a hole with the ⅜” bit, long enough for the wheel insert, into each chair leg. Dab some super glue onto each wheel insert, then tap into place with a hammer.

step-2Spray the chair cobalt blue. You’ll want to do this outside or in a well-ventilated area, and on some cardboard or a plastic dropcloth. Spray it from all angles, in 2-3 light coats, to prevent drips. Let the chair dry 1 hour.

step-3 Spray the wheels gold from every angle, and let dry 1 hour.

step-4Measure the diameter of the seat, then use a pencil, a sharpie, and some string to trace a circle of the same size on the foam.

step-5 Use a bread knife to cut out the foam circle. Make sure to hold it perpendicular to the sheet as you go around so the circle doesn’t come out with angled edges.

step-6Trace a circle 1” larger in diameter on the backside of the fabric. Cut two out two circles of fabric (you can stack two layers of fabric and cut them both out together). Measure the length around the circle, then cut a strip of fabric that long and 2 ½” wide.

step-7 Hot glue foam circle to the two fabric circles, one on either side. Fold down the extra fabric around the rim on each side and glue in place.

step-8Fold down the sides of the strip of fabric to create a faux seam and hot glue around the side of the foam circle.

step-9 Place the wheels into each insert and pop the cushion onto the chair seat, and you’re ready to work!

Photography: Nicole Baas | Design and Styling: SMP Living